The Ceriatone Overtone Special HRM 100 is another unique Ceriatone perspective on classic American high-gain tone. The Overtone Special HRM is a version of a particular circuit iteration. These amps are commonly referred to as “HRM”, which is a tip of the hat to hot-rodded British guitar tones.
HRM amps have an internal adjustable tonestack (treble, middle, bass) for the overdrive channel. This allows the player to fine tune gain tone to their liking. Also unique to the HRM amplifier, each channel has it’s own independent Master Volume control. These amplifiers generally sound more aggressive than their non-HRM counterparts, especially when the Preamp Boost is engaged.
Like other OTS amps, we have labored carefully to select the finest components to suit the design. As with all Ceriatone amplifiers, it uses our specially designed, custom transformers for superior reliability, frequency response, and feel.
Note: PPIMV mounted on Front Panel will be either mounted in place of pilot lamp (Marshall styles) or a hole will be drilled (OTS styles).
PPIMV mounted on Rear Panel will always be in place of a Speaker Output Jack.
Power Output 100 Watt
Hi and Lo Inputs
Push-pull Bright switch on Gain control
Mid-boost, Deep, and Rock/Jazz toggle switches
Treble, Middle, Bass equalization (shared between channels)
Overdrive channel with Drive and Level controls
Internal Treble, Middle, Bass tonestack trimmers (overdrive channel)
Separate Master Volume controls for each channel
Footswitch (Channel and Preamp Boost)
Rear panel OD Trim (fine tunes response of overdrive channel)
Passive effects loop
Full/Half Power switch
4 / 8 / 16 Ohm Selectable
Dual Speaker Outputs
External Bias Adjust
Power : 4 x 6L6GC
Preamp : 3 x 12AX7/ECC83
Rectifier : Solid State
OTS HRM 100 Watt Configuration Options:
- Chassis I - $1,141.50
(Fully working chassis w/ footswitch. Tubes and cabinet not included.)
- Chassis II - $1,258.50
(Fully working chassis w/ tubes and footswitch. Cabinet not included)
- Amp Head I - $1,373.50
(Fully working chassis installed in a head cabinet w/ footswitch. Only tubes not included.)
- Amp Head II - $1,490.50
(Fully working chassis w/ faceplate and tubes installed in a head cabinet. Includes footswitch.)
- Amp Head w/ C-lator Built In - $1,776.50
(Fully working chassis w/ footswitch installed in a head cabinet with a C-lator. Tube driven Effect Loop Buffer built into the cabinet.)
- 112 Combo Amp I - $1,466
(Fully working chassis w/o tubes installed in a 1x12 combo cabinet w/ footswitch. Speaker not included.)
- 112 Combo Amp II - $1,583
(Fully working chassis w/ tubes installed in a 1x12 combo cabinet w/ footswitch. Speaker not included.)
Main photo is for illustrative purposes only and pricing is for Chassis I. Photos may include options that are not included if you order the standard version of the amp or don't order all options available. We also may not offer all options available and/or shown in main illustrative photos. Photos are of products assembled by Ceriatone. We no longer sell kits. You must order all kits direct from Ceriatone Malaysia. Ordering options for your amp may add several days to the build/lead time.
Ceriatone amps are Custom made, hand wired amps, built to order. There is meticulous attention to detail that is second to none, and no shortcuts are taken. Each amp is 100% hand built, hand wired point to point, and then is thoroughly tested and burned in before it is shipped to you. For this reason it takes approx. 6-8 weeks for your amp to be built and shipped. Options can add 1-2 weeks to the "standard" build time.
Prices shown on www.guitarampsusa.com includes the shipping cost to the USA only. We only ship to the USA, Canada and Mexico. Shipping to Canada, Mexico, Puerto Rico and the US Virgin Islands will have additional shipping. We'll invoice the difference in shipping and it is due at time the order is placed.
Note: We ONLY ship to PayPal verified addresses if paying via PayPal. No exceptions.
OTS HRM 100 Watt
- Brand: Ceriatone Amplification
- Product Code: OTSHRM1
- Availability: In Stock